Flex EX2 Receiver Select Instruction Manual
August 2018
Page 10 of 39
Radio controlled equipment should not be operated by any person with insufficient eyesight or hearing or
by any person who may be suffering from a disorder or illness that may cause them to lose control of the
equipment, is taking any medication that may cause loss of equipment control, or is under the influence of
alcohol or drugs.
2.4 Safety Information and Recommended Training for
Radio Controlled Equipment Operators
Anyone being trained to operate radio controlled equipment should possess as a minimum the following
knowledge and skills before using the radio controlled equipment.
The operator should:
• have knowledge of hazards pertaining to equipment operation
• have knowledge of safety rules for radio controlled equipment
• have the ability to judge distance of moving objects
• know how to properly test prior to operation
• be trained in the safe operation of the radio transmitter as it pertains to the crane, hoist, lifting
device or other material handling equipment being operated
• have knowledge of the use of equipment warning lights and alarms
• have knowledge of the proper storage space for a radio control transmitter when not in use
• be trained in transferring a radio control transmitter to another person
• be trained how and when to report unsafe or unusual operating conditions
• test the transmitter emergency stop and all warning devices prior to operation; testing should be
done on each shift, without a load
• be thoroughly trained and knowledgeable in proper and safe operation of the crane, hoist, lifting
device, or other material handling equipment that utilizes the radio control
• know how to keep the operator and other people clear of lifted loads and to avoid "pinch" points
• continuously watch and monitor status of lifted loads
• know and follow cable and hook inspection procedures
• know and follow the local lockout and tagout procedures when servicing radio controlled
equipment
• know and follow all applicable operating and maintenance manuals, safety procedures, regulatory
requirements, and industry standards and codes
The operator shall not:
• lift or move more than the rated load
• operate the material handling equipment if the direction of travel or function engaged does not
agree with what is indicated on the controller
• use the crane, hoist or lifting device to lift, support or transport people
• lift or carry any loads over people
• operate the crane, hoist or lifting device unless all persons, including the operator, are and remain
clear of the supported load and any potential pinch points
• operate a crane, hoist or lifting device when the device is not centered over the load
• operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the
sprockets, drum or sheave
• operate any damaged or malfunctioning crane, hoist, lifting device or other material handling
equipment
• change any settings or controls without authorization and proper training
• remove or obscure any warning or safety labels or tags
• leave any load unattended while lifted
• leave power on the radio controlled equipment when the equipment is not in operation
To Next Page
Loading...
Need help?
General
