Magnetek Flex EX2 series User Manual

Flex EX2 Receiver Select Instruction Manual
August 2018
Page 18 of 39
3.2.4 Internal Illustration (12EX2)
* The programming port is only used for updating the transmitter firmware. It is not used with the
IR Programmer. For more information, contact Magnetek field service.
1. RF Transceiver Board 5. Infrared Sensors
2. Encoder Board 6. I-Chip Slot
3. Status LED Indicator 7. Function Dipswitch
4. A/B/C/D LED Indicators 8. Programming Port*

Magnetek Flex EX2 series Specifications

General

Battery Type	3 AA batteries
Enclosure Rating	IP66
Number of Buttons	Up to 12
Power Source	3 AA batteries
Battery Life	Up to 100 hours
Housing Material	Engineered Plastic
Operating Range	Up to 300 ft (91 m)