Magnetek Flex EX2 series User Manual

Flex EX2 Receiver Select Instruction Manual
August 2018
Page 24 of 39
4.1.6 Transmitter Inactivity Timer Settings
After 5 minutes (default) of the transmitter pushbuttons not being pressed, the system
will go into Sleep mode and the receiver MAIN relays will be deactivated.
4.1.7 Zero-G Sensor Settings
The transmitter is embedded with a Zero-G sensor to guard against any unintended
control of the crane or equipment when the transmitter is dropped. By default, the
sensor is disabled. When the sensor is enabled and a drop is detected, the receiver
MAIN relays are deactivated. Please contact Magnetek field service for more details.
4.1.8 Transmitter Start Function Settings
When the transmitter goes into Sleep mode and the receiver MAIN relays are
deactivated, execute the START command (default) or press any pushbutton to
reactivate the MAIN relays.
Dipswitch
Settings
Time
Dipswitch
Settings
Time
1 xxx000xxxx 1 minute 5 xxx100xxxx 10 minutes
2 xxx001xxxx 20 seconds 6 xxx101xxxx 30 minutes
3 xxx010xxxx 3 minutes 7 xxx110xxxx 60 minutes
4 xxx011xxxx 5 minutes 8 xxx111xxxx
Constant On (Sleep
mode disabled)
Dipswitch
Settings
Function
1 xxxxxxxx0x Sensor Disabled
2 xxxxxxxx1xSensor Enabled
Dipswitch
Settings
Output Power
1 xxxxxxxxx0
START
Reactivation
2 xxxxxxxxx1
Any Button
Reactivation

Magnetek Flex EX2 series Specifications

General

Battery Type	3 AA batteries
Enclosure Rating	IP66
Number of Buttons	Up to 12
Power Source	3 AA batteries
Battery Life	Up to 100 hours
Housing Material	Engineered Plastic
Operating Range	Up to 300 ft (91 m)