Diagnostic Manual MAN-00183
MAXXIMO MINIVAN VX June 2012/Rev 1
The reproduction, translation, transmission, in part of or whole of the present document are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any
person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution. © 2012 Mahindra &
Mahindra Ltd.
15
ECU
P 1210
Chip internal reset/clock loss/ under voltage inside the ECU
186
P1260
Over temperature of pressure control valve power stage
ECU
P0107
Environment pressure sensor voltage below lower limit
187
P0108
Environment pressure sensor voltage above upper limit
ECU
P1900
Diagnostic fault check to report the NTP error in ADC
monitoring
188
P1901
Error during SOP test ;Uncertain cause
P1902
Diagnostic fault check to report the ADC test error
P1903
Diagnostic fault check to report the error in voltage ratio in
ADC monitoring
P1904
Diagnostic fault check to report errors in query-/response-
communication
P1905
Interrupted SPI communication
P1906
Diagnostic fault check to report multiple error while checking the
complete ROM –memory
P1907
Loss of synchronization sending bytes to the MM from CPU.
P1908
Error trying to set MM Response time
P1909
Too many SPI errors during MoCSOP execution.
P1910
Diagnostic fault check to report the error in overvoltage
monitoring
P190A
Expiration of the waiting time due to hardware not active
P190B
Error in the check of the shut-off path test of the under voltage
detection
P190C
Diagnostic fault check to report that WDA is not working correct
P190D
OS timeout in the shut off path test. Failure setting the alarm task
period.
P190E
Time out while requesting an injection
P190F
Timeout in the shut off path test
To Next Page
Loading...
