15-10
© Copyright Mahindra and Mahindra Ltd. 112020
3. The picture shows a correctly fitted sensor. Note the rubber
bulb of the valve resting against the rim and the front face of
the enclosure is NOT touching the rim. Apply tyre soap solution
to the rubber portion of the valve stem and the top of the
enclosure
4. Place the inner tyre bead over the rim
5. Place the outer tyre bead over the rim
6. Inflate all tyres to the prescribed pressure, check the valve
area for leakage and re-balance the wheels prior to installing
back on the vehicle
Starting to mount the tyre from the valve location is a wrong
fitment. The fixing tool/stem may hit the sensor and damage it.
Start from the opposite direction.
1155..66..44 TTiirreettrroonniiccss SSeennssoorr RReemmoovvaall
1. Remove the tyre from the rim
2. To remove the sensor, firstly remove the screw using a T10
TORX screwdriver
3. Carefully and firmly pull the enclosure straight back off the
valve
WWHHEEEELLSS AANNDD TTYYRREESS
To Next Page
Loading...
