Operation Manual easyTymp
5.5.7 easyTymp Plus and Pro Version: Contra Probe Button
The Contra Probe button will change ears as long as the probe detects it is not in the ear.
When the probe is in an ear it will interrupt the testing and bring you to the Done! Screen,
and from there also back to the Test screen with a second press of the button. If a protocol
includes an instruction message, pressing the Contra Probe button results in continuing
the protocol, no matter what the probe status.
5.5.8 Select Patient & Save
The Select Patient & Save screen is accessible once a
measurement is completed and is selected form
the test screen. Results can either be saved to an existing
patient or to a new patient (Figure 56). New patient will
always get the name “New Patient: Number #”, where # is
always the next available number.
When saving results to a patient, the patient management
function must be On in the settings (see section 5.6.8).
Operating from this screen:
- will bring you back to the Done! screen without saving and without
deleting data.
- opens a screen for editing new patient details.
- will save the data to the selected patient. After saving, all data is deleted
and easyTymp returns in the Test screen, ready for testing.
- buttons will bring you to the top or bottom of the patient list respectively.
- buttons scroll up or down as one patient’s information is viewed.
5.5.9 Edit New
With this screen you can input data for a new patient
before saving the measurement (Figure 57).
To Next Page
Loading...
Need help?
General
