FM Radio
Press the ‘Power/Mode’ button (Ref.3) multiple times to switch
to FM. The first time you do this, FM frequency “87.5 MHz” will
be displayed on the screen.
Fully extend the antenna (Ref.11).
To auto-scan press and release the ‘Scan’ button (Ref.4).
This will then start scanning up the frequency band and play
the first station it finds with a good signal.
To scan down the frequency band press and hold the ‘Scan’
button (Ref.4) for a few seconds.
The radio will display station information when you press the
‘Info/Menu’ button (Ref.1). Press multiple times to view all
information available (See page 11).
IMPORTANT: Please make sure you have
extended the antenna to its full length
(Ref.11). This will then enable you to rotate
it to get the best signal.
To Next Page
Loading...
Need help?
General