MakerBot Replicator - Package Contents; Safety Information; Trademark Information

2 The Replicator™ Setup Guide
PACKAGE CONTENTS
IN THE REPLICATOR PACKAGE
 The Replicator™
 SD card (in The Replicator™ SD card slot)
IN THE ACCESSORY BOX FOUND WITHIN
THE REPLICATOR FRAME
 Single or Dual Stepstruder
®
MK8
 120 mm Kapton tape
 1x or 2x spool holders
 Feet and Bolts Kit
 Hex Wrench Kit
 MakerBot tape applicator
 Calibration card
 Service Kit
INSIDE THE REPLICATOR™ FRAME AND BELOW THE
PRINTING PLATFORM
 
 
(included with Dual Stepstruder
®
MK8 models only)
UNDERNEATH THE REPLICATOR
 Power supply
 Power supply cable
 USB-A to USB-B cable
 
SAFETY INFORMATION
CAUTION: The Replicator generates high temperatures and includes moving parts that can cause
injury. Never reach inside The Replicator while it is in operation and allow time for The Replicator
to cool down after operation.
TRADEMARK INFORMATION
MakerBot
®
, Stepstruder
®
, BotCave™ and The Replicator™ are trademarks or registered trade-
marks of MakerBot Industries, LLC, all rights reserved.
WARNING
Burn hazard. Hot surface inside.
Allow to cool before servicing.
WARNING
Moving parts can crush and cut.
Keep hands clear while operating.
Vapors / fumes may be irritating at
operating temperatures. Always use The
Replicator in an open, well-ventilated area.
Do not leave The Replicator unattended
during operation.
Contact with extruded material may cause
burns, wait for printed objects to cool before
removing them from the build platform.