What to do if the cutting tool of my Makita Trimmer does not rotate?
If the cutting tool on your Makita Trimmer isn't rotating, a foreign object, like a branch, might be jammed between the guard and the nylon cutting head. Remove the foreign object.
What to do if my Makita DUR366L Trimmer motor stops running after a little use?
If the motor of your Makita Trimmer stops running shortly after you start using it, consider the following possibilities: 1. The rotation might be in reverse. Try changing the direction of rotation using the reversing switch. 2. The battery's charge level could be low. Recharge the battery, and if that doesn't work, replace it. 3. The trimmer may be overheating. Stop using the tool and allow it to cool down.
What to do if the cutting tool and motor of my Makita DUR366L cannot stop?
If the cutting tool and motor of your Makita Trimmer won't stop, remove the battery.
What to do if my Makita Trimmer cutting tool does not rotate?
If the cutting tool of your Makita Trimmer doesn't rotate, stop the machine immediately! It may be because: * A foreign object, like a branch, is jammed between the guard and the nylon cutting head. Remove any foreign objects. * The drive system may not be working correctly. Ask your local authorized service center for repair.
What to do if my Makita DUR366L Trimmer cutting tool and motor cannot stop?
If the cutting tool and motor of your Makita Trimmer cannot be stopped, remove the battery immediately! This is most likely due to an electric or electronic malfunction. Remove the battery and ask your local authorized service center for repair.
Why won't my Makita Trimmer motor run?
The motor of your Makita Trimmer might not be running because the battery cartridge isn't installed properly, so install the battery cartridge. Another reason could be a battery problem, such as undervoltage, in which case you should recharge the battery, and if that doesn't work, replace it.
What to do if Makita DUR366L Trimmer motor stops after short use?
If your Makita Trimmer's motor stops running after a short period, it could be due to the rotation being in reverse. Change the direction of rotation with the reversing switch. Alternatively, the battery's charge level might be low, so recharge the battery; if that doesn't help, replace the battery. Overheating can also cause this issue; stop using the tool to allow it to cool down.
Why is my Makita Trimmer not reaching maximum RPM?
Your Makita Trimmer might not be reaching maximum RPM because the battery is installed improperly; install the battery cartridge as described in this manual. Another cause could be dropping battery power, so recharge the battery, and if recharging isn't effective, replace the battery.
Why doesn't my Makita DUR366L reach maximum RPM?
Your Makita Trimmer might not be reaching its maximum RPM due to a few potential issues: * The battery may be installed improperly. Make sure to install the battery cartridge as described in the manual. * The battery power could be dropping. Recharge the battery, and if that doesn't solve the problem, replace the battery. * There might be a problem with the drive system. Contact your local authorized service center for repair.
What to do if my Makita Trimmer has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, stop the machine immediately! This could be due to: * One end of the nylon cord being broken. Bump the nylon cutting head against the ground while it is rotating to cause the cord to feed. * A problem with the drive system. In this case, seek assistance from your local authorized service center for repair.
Provides crucial safety warnings and instructions for safe operation.
Describes the integrated system that protects the tool and battery during operation.
Details the mechanism that stops the tool when it's overloaded.
Explains the system that prevents the tool from overheating.
To Next Page
General
