What to do if Makita DUR369LPT2 motor stops running after a little use?
If your Makita Trimmer motor stops running shortly after you start using it, it could be due to a low battery. Try recharging the battery cartridge, and if that doesn't solve the issue, replace the battery. Alternatively, the tool might be overheating. If this is the case, stop using the trimmer and allow it to cool down.
What to do if Makita Trimmer cutting tool does not rotate?
If the cutting tool on your Makita Trimmer isn't rotating, stop the machine immediately! Check if a foreign object, like a branch, is jammed between the guard and the cutting tool and remove it. Also, verify that the cutting tool is securely tightened. If the problem persists, the drive system may not be working correctly, and you should contact your local authorized service center for repair.
Why my Makita Trimmer motor does not run?
If the Makita Trimmer motor isn't running, first, ensure the battery cartridge is correctly installed. If it still doesn't work, the battery might be the issue. Try recharging it, and if that doesn't help, replace the battery cartridge. If problems persist, the drive system may not be working correctly, and you should seek repair at your local authorized service center.
Why my Makita DUR369LPT2 does not reach maximum RPM?
If your Makita Trimmer isn't reaching its maximum RPM, start by checking if the battery cartridge is properly installed as described in the manual. If it is, the battery power might be dropping. Try recharging the battery cartridge, and if that doesn't work, replace it. If the issue continues, the drive system may not be functioning correctly, and you should consult your local authorized service center for repair.
What to do if Makita Trimmer has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, stop the machine immediately! This could be due to a broken, bent, or worn cutting tool, which requires replacement. It could also be that the cutting tool is loosely attached, so tighten it securely. If neither of these solutions works, the drive system may not be functioning correctly, and you should seek assistance from your local authorized service center.
What to do if Makita DUR369LPT2 cutting tool and motor cannot stop?
If the cutting tool and motor on your Makita Trimmer cannot be stopped, remove the battery immediately! This likely indicates an electric or electronic malfunction. Remove the battery cartridge and seek assistance from your local authorized service center for repair.
General| Power Source | Battery |
|---|---|
| Battery Voltage | 36V |
| Battery Type | Lithium-Ion |
| Motor Type | Brushless |
| Voltage | 36V |
| No Load Speed | 6500 rpm |
| Line Diameter | 2.0 mm |
| Spindle Size | M10 x 1.25 |
To Next Page
