Caution:
1. Carefully wipe the contacts of the
battery before inserting it into the
chamber. Failure to do this could result
in
poor
electrical contact and conse-
quent erratic functioning of the camera.
2. When the
camera
is not used for a
long period of time, remove the battery
and store it in a
cool,
dry place.
3.
Battery
life differs, depending on
battery brand, period after manufac-
ture, storage conditions, temperature
during operation and operating fre-
quency. Prior to use, check the battery
condition, using a battery checker.
It is recommended that you take a
spare battery with you when going out
on a photographic trip, for example.
4. This camera is designed for use
with either a silver-oxide or alkaline-
manganes battery. However. the life of
a silver-oxide battery will be much
longer. The silver-oxide battery is
pre-
fered
when the AE Prism Finder is
attached.
At times it may be necessary to rotate
the film advance crank two full
turns
to
cock the shutter when an empty take-up
Operation Test
/
@I
Remove the Dark Slide
Pull out the Dark
slide
and place it
into the Dark Slide Storage Slot.
i
:
-.
-_
\2
Set the Lever to “MULTI,”
Set the Multiple Exposure
Lever to
the “MULTI
0”
mark position.
I
-
----
‘.
!
.3
Turn the Wind-up Crank
Advance the
Wind-up
Crank one
complete revolution.
@ll
Release the Shutter
Set the Shutter Release Selector
to the
“m
mark, and press the
button.
To Next Page
Loading...
