In
the same manner, insert a roll of film
in the upper compartment. At that time,
check that the film leader paper is set
as shown in the photo above. (The
leader paper inside is facing outward
on the pressure plate. Note that the
film direction is wrong if the leader
paper is facing inward.)
Pull out some of the leader paper.
Gently rotate the Take-up Spool in the
Insert the tip of the leader paper into
direction of the arrow until the start
the slot of the lower Take-up Spool.
mark of the leader paper is aligned
with the start mark (A) on the Spool
Clip. (Correctly align the
start
marks
with each other, taking care that the
film is not rolled excessively.)
15
To Next Page
Loading...
