Film type index (120 or
220)
Pro-SD Outer
cassette
Back cover
Dark slide slot
Accepts
the dark slide from either the
right
or left side.
Film spool stud
Load film so that
th
pulled out following the guide marks.
Guide mark for leader paper
___________________
Starting mark
Wind the film advance lever until the
leader paper staring mark is aligned
with this mark. After closing the
back
cover, wind the lever several
strokes,
and it will stop at the first
exposure
Exposure counter
When the film is advanced and the
shutter is released,
a
red mark appears
on the side of the counter digits. When
the next film advance is completed,
the red mark disappears. The red mark
also appears while the film is being
advanced from S to 1
.
Multiple exposure lever
When multiple exposures are desired,
simply
move
this lever to the front until
the red mark becomes visible.
Safety-catch for dark slide
When the film holder is being carried
about after detaching it from the
camera body, the safety device pre-
vents the dark slide from accidentally
slipping off.
When the
film
holder is attached to
the camera body, the dark slide can be
removed automatically.
Back cover latch
(top and bottom)
To open back cover, both top and
bottom latches must be pulled out.
Spool release pin
The film spool is attached and
detached by pressing down this pin.
Take-up
spool stud
After
inserting the take-up
spool,
the
leader paper is inserted in the spool.
position.
7
To Next Page
Loading...
