9
10
11
Removing and installing piston with connecting rod
107
Fig. 9
Put connecting rod bearing caps in place.
Important:
The numbers on the connecting rod bearing
cap and connecting rod big end must be on
one side.
Fig. 10
Screw in connecting rod bearing bolts and tighten
them in stages to specified value.
Tighten finally by angle.
(For tightening torques and reusability of bolts, see
”Engineering S Data S Setting values”.)
Fig. 11
Slowly turn engine over.
Connecting rods and oil spray nozzles (arrow)
must not collide or grind against each other.
Note:
As far as possible turn engine only in direc-
tion of rotation (anti-clockwise as seen when
looking at the flywheel) in order to prevent
the direction of rotation of the raw water
pump impeller being reversed.
3560
3726
3462
To Next Page
Loading...
Need help?
General
