1
2
3
4
V-belts
117
Checking condition
Fig. 1
D Check V-belts for cracks, oiling, overheating
and wear.
D Change damaged V-belts.
Checking tension
Figs. 2 and 3
Use belt tension indicator to check V-belt tension.
D Lower the gauge arm À in the scale.
D Position the tension indicator in the centre of
the belt between the two pulleys so that the
edge of the stop face Á locates against the side
of the belt.
D Slowly depress the pressure pad  vertically
downwards until the spring disengages with an
audible click; the gauge arm moves upwards.
A false reading will be obtained if you continue to
apply pressure after the spring has disengaged.
Fig. 4
Taking tension reading
D The tension is shown where the top of the
gauge arm (1 in picture 2) intersects the kg
scale.
D Ensure that the gauge arm does not move be-
fore you take the reading.
If the reading does not correspond with the speci-
fied value, the V-belt tension must be corrected.
2642
1
2905
2
3
2906
Tensioning forces as per kg scale on
the indicator
V-belt
for newly fitted
assembly
for mainte-
nance af-
width
after as-
sembly
after a
running
time of
10 min.
ter prolon-
ged pe-
riods of
operation
B 12,5 50-55 45-50 35
C 13 50-55 40-45 35
2/3VX 90-100 70-80 60
To Next Page
Loading...
