3 - 21
D7 - MAST LIFTING CHAINS
CLEAN - CHECK - GREASE
- Wipe the mast lifting chains 1 (Fig. D7) with a clean, lint-free cloth, then examine them
closely so as to detect any signs of wear.
- Vigorously brush the chains to get rid of any foreign matter, with a hard nylon brush
and clean diesel fuel.
- Rinse the chains by means of a paint brush impregnated with clean diesel fuel and dry
them with a compressed air jet.
- Moderately lubricate the chains with a paint brush impregnated with oil (See chapter :
LUBRICANTS AND FUEL in paragraph : 3 - MAINTENANCE).
- Remove the excess of oil with a clean cloth on the full length of the mast lifting chains.
In case of technical faults, consult your dealer.
D8 - HYDRAULIC RETURN OIL FILTER CARTRIDGE
CHANGE
Thoroughly clean the outside of the filter and its surroundings before any
intervention in order to prevent any risk of polluting the hydraulic circuit.
- Open the I. C. engine bonnet.
- Unscrew the locking screws of the cover 1 (Fig. D8).
- Remove the hydraulic return oil filter cartridge 2 (Fig. D8), and fit new replacement
cartridge (See chapter : FILTERS CARTRIDGES AND BELTS in paragraph : 3 -
MAINTENANCE).
- Make sure that the cartridge is correctly positioned and refit cover 1 (Fig. D8).
D9 - PARKING BRAKE MECHANISM
GREASE
- Release the protective boot 1 (Fig. D9).
- Clean and grease articulation axles 2 (Fig. D9) with grease (See chapter :
LUBRICANTS AND FUEL in paragraph : 3 - MAINTENANCE).
- Refit the protective boot 1 (Fig. D9).
D8
D9
D7
1
1
2
1
2
2
2
To Next Page
Loading...
Need help?
General