• Do not use high-pressure water guns to spray or
rinse the interior or exterior of the unit. Do not use
power cleaning equipment, steel wool, wire brushes,
scrapers, etc. to clean the exterior of the equipment.
• To prevent tipping, two or more people are needed to
move this appliance.
It is the responsibility of the end user to lock the front
casters after the device has been moved. When casters
are installed the mass of this unit will allow it to move
uncontrolled on an inclined surface. These units must
be tethered/secured to comply with all applicable
codes.
• It is the responsibility of the site supervisor to ensure
that operators fully understand the dangers inherent in
operating this equipment.
• Do not operate any equipment with damaged cords
or plugs. All repairs must be performed by a qualified
service company.
• Moisture collecting on the floor will create a slippery
surface. Clean up any water on the floor immediately
to prevent a slip hazard.
To Next Page
Loading...
Need help?
General