Marantz AV8802/U1B - Page 76

1.4. Insert the USB memory in the USB port.
NOTE
：
Remove the LAN cable from this unit when performing updates.
1.5. Start the update.
Hold down buttons "
HDMI OUT
" and "
STATUS
" at the same time and press the power button to turn on the power.
1.6. Display during USB update
The following message appears on the display after around 30 seconds
Display
FLD
L1
* F I R M W A R E U P D A T E
L2
U S B U p d a t e S t a r t
1.7. Press the "ENTER" key on the remote control unit or this unit.
Then start Firmware Update.
Display
FLD
L1
P l e a s e w a i t . . .
L2
U p d a t e F i l e C h e c k
1.8. Thermwareupdatenishes.
When the update is completed, the normal status resumes after the following message appears on the display.
Display
FLD
L1
F i r m U p d a t e
•
L2
U p d a t e C o m p l e t e
--- Precautions for Updates ---
•NeverremovetheUSBmemorybeforetheupdateisnished.
• Never turn off the power before an update is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Takenoteofyoursettingsbeforehandandrecongurethemaftertheupdate.
Download firmware in
USB flash drive.
76