Filter
This unit is equipped with a sound quality adjusting function which allows
users to enjoy the desired playback sound quality. The unit supports PCM
signal.
FIL 1
(Default):
Offers a short impulse response for both
pre-echo and post-echo. Suitable for large-
informationcontent audio. Produces a deep
sound image with clearly-defined positional
relationships of the audio sources.
FIL 2:
This characteristic is known as
asymmetrical impulse response. The post
echo is slightly longer than the pre-echo.
The sound characteristics is more analog
like.
H/P Gain
Set the gain of the headphone amplifier. Set this according to the
impedance of the connected headphones. It is recommended that this is
set on the “Low” side if the headphones have low impedance and on the
“High” side if they have high impedance.
Low
(Default):
Set the gain of the headphone amplifier to
“Low”.
Mid:
Set the gain of the headphone amplifier to
“Mid”.
High:
Set the gain of the headphone amplifier to
“High”.
NOTE
0
The headphone volume varies depending on the “H/P Gain” setting. Decrease the
volume or mute the audio first if changing this setting while listening to audio.
Contents Connections Playback Settings Tips Appendix
53
Front panel Display Rear panel Remote Index
To Next Page
Loading...
