Dimmer
This switches the brightness of the display.
Off: Turns the display off.
Dark: Very low display brightness.
Dim: Reduced display brightness.
Bright
(Default):
Normal display brightness.
0
You can also adjust the display by pressing DIMMER on the remote control unit.
iPodMode
Set whether to operate the iPod from this unit or on the iPod.
From iPod:
Operate the iPod on the iPod itself.
On-Display:
Operate the iPod from this unit and the remote
control unit.
0
Operation mode can also be switched by pressing MODE on the remote control
unit.
AutoStby
When this unit is in the stop state and there is no input signal and
operation for 30 minutes, it automatically enters the standby mode.
On: Enable Auto Standby mode.
Off
(Default):
Disable Auto Standby mode.
0
When iPod is being charged, this unit enters the power standby mode after
charging.
Contents Connections Playback Settings Tips Appendix
54
Front panel Display Rear panel Remote Index
To Next Page
Loading...
