o
Desired sound does not come out
Symptom Cause / Solution Page
Left/right volume balance is
unbalanced.
0
Press the SETUP button on the remote control to adjust the balance. 52
No sound from the
subwoofer.
0
Check the subwoofer connections. 19
0
Switch the subwoofer power on. －
Set values are not reflected
in “Bass” and “Treble”.
0
“Bass” and “Treble” setting values are not reflected in Subwoofer out. 52
0
Set “Off” to the “S.Direct”. 52
Headphone volume is low.
0
Switch “H/P Gain” to “Mid” or “High” if using headphones with high impedance or low sensitivity. 53
o
PC or Mac files cannot be played back
Symptom Cause / Solution Page
This unit is not recognized
on the computer.
0
Reconnect the USB cable to the USB port on your computer. When this unit is still not recognized after
reconnection, connect to a different USB port.
21
0
Restart your computer. －
0
Check the OS of your computer. 31
0
When your computer is running on Windows, a dedicated driver software should be installed. 31
This unit is not selected as
the playback device.
0
Select this unit as the playback device in the sound settings on the computer. 31
“Unlocked” is displayed.
0
When digital audio signals cannot be detected properly, “Unlocked” is displayed. 39
“Unsupported” is
displayed.
0
“Unsupported” is displayed when audio signals that are not supported by this unit are input. Check the
settings on your computer or player software.
39
0
If the computer you use is “Mac OS”, please check if the “HD-AMP1” format is set below “384000.0 Hz”
using the “Audio MIDI Setup”.
38
Contents Connections Playback Settings Tips Appendix
61
Front panel Display Rear panel Remote Index
To Next Page
Loading...
