No sound comes out
No sound is produced. Or sound is distorted.
0
Check the connections for all devices. (v p. 19)
0
Insert connection cables all the way in.
0
Check that input connectors and output connectors are not reversely connected.
0
Check cables for damage.
0
Check that speaker cables are properly connected. Check that cable core wires come in contact with the metal part on speaker terminals. (v p. 20)
0
Securely tighten the speaker terminals. Check speaker terminals for looseness. (v p. 20)
0
Check that the proper input source is selected. (v p. 31)
0
Adjust the volume. (v p. 31)
0
Cancel the mute mode. (v p. 31)
0
Check that the correct input source is selected when audio is being input to this unit from an external device. (v p. 31)
0
Check the digital audio output setting on the connected device. The initial settings may be off depending on the device.
0
When a headphone plug is inserted into the headphone jack of the unit, no sound is output from the speakers. (v p. 12)
0
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes noise and could damage the speakers.
0
To playback via a Bluetooth connection, perform pairing between this unit and the Bluetooth device. (v p. 49)
0
It may be that only speaker A or speaker B is selected. Make sure the speakers are correctly connected then push the SPEAKER A/B button to check.
(v p. 59)
Contents
Connections Playback Settings Tips Appendix
79
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
