EasyManua.ls Logo

Marantz M-CR510 - Firmware update

Marantz M-CR510
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71
Appendix
TipsPlaybackConnections
Contents
Front panel Rear panel IndexRemote
Settings
Language
Set the language for display on the menu.
English (Default) / Français / Español
Auto-Standby
When this unit is in the stop state and there is no input signal and operation
for 15 minutes, it automatically enters the standby mode.
For the input source “Analog In” and “Direct iPod” only, when no
operation is performed for eight hours, this unit automatically enters the
standby mode.
On : The unit goes into standby after 15 minutes.
O (Default) : The unit does not go into standby automatically.
Firmware
Set whether or not to check for firmware update, update the firmware,
and display update, upgrade and alert notifications.
2 Update
Update the firmware of Marantz Network Receiver.
Check for Update : Check for firmware updates. You can also check
approximately how long it will take to complete
an update.
Update Start : Execute the update process.
%
•If updating fails, the set automatically retries.

Table of Contents

Other manuals for Marantz M-CR510

Related product manuals