Using as a D/A converter
Connect and playback from a digital
device (Optical)
1
Press the input source select button (OPTICAL) to
switch the input source to “Optical”.
The digital audio signal that is being input is shown as follows in the
display.
.
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
o
Files that can be played back
See “D/A converter” (v p. 115).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0
If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
Contents
Connections Playback Settings Tips Appendix
81
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
