Marantz PM-11S2 Service Manual

1
27
NAMES AND FUNCTIONSBASIC CONNECTIONSBASIC OPERATIONS
ADVANCED CONNECTIONS
ADVANCED OPERATIONSTROUBLESHOOTINGOTHERSOTHERS
ENGLISH
OTHERS
SPECIFICATIONS &
DIMENSIONAL DRAWINGS
Power output
(20 Hz – 20 kHz simultaneous drive of both channels)
.....................................................100W x 2 (81 load)
.....................................................200W x 2 (41 load)
Total frequency distortion
(20Hz – 20kHz simultaneous drive of both channels, 81 load)
..........................................................................0.01%
Output band width (81 load, 0.05%) .................. 5Hz ~50kHz
Frequency response (CD, 1W, 81 load) ..5Hz ~ 120kHz±3dB
Dumping factor (81 load, 20Hz – 20kHz) .........................100
Input sensitivity/Input impedance
PHONO (MC) ................................................270µV/1001
PHONO (MM) ..................................................3mV/47k1
BALANCED .................................................480mV/20k1
CD/LINE ....................................................... 240mV/20k1
Output voltage/Output impedance
PRE OUT ........................................................1.9 V/2201
Maximum allowed PHONO input (1kHz)
MC .......................................................................... 12mV
MM ........................................................................ 130mV
RIAA deviation (20Hz ~ 20kHz) ............................ ±0.5dB
S/N (IHF-A, 1W, 81 load)
PHONO (MC) ..................................... 76dB (0.5mV input)
PHONO (MM) .......................................90dB (5mV input)
BALANCED .............................................95dB (1V input)
CD/LINE ............................................ 96dB (500mV input)
Tone control
Bass (50Hz) ............................................................. ±8dB
Treble (20kHz) .......................................................... ±8dB
Power requirement
...............................................AC 120V 60Hz (U.S.A.)
........................................ AC 230V 50/60Hz (Europe)
Power consumption
(EN60065 7th Ed.) .................................................. 300W
(UL60065) ............................................................... 300W
Accessories
Remote controller ...........................................................1
AAA batteries ..................................................................2
Detachable AC power cable ............................................1
Maximum outer dimensions (Amp)
Width ................................................ 17-3/8 ins. (440 mm)
Height ................................................6-5/8 ins. (168 mm)
Depth ............................................... 17-1/2 ins. (444 mm)
Weight (Amp) .............................................. 58.6 lbs (26.6 kg)
POWER ON/OFF
PHONES
VOLUME
A
TONE
SPEAKER
B
SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR
INPUT
6-5/8 (168)
3/16 (4)
5-3/4 (146)
3/4 (18)
17-3/8 (440)
17-1/2 (444)
3/4 (19)
1 (25)
15-3/4 (400)
Unit: inch (mm)
Specifications subject to change without prior notice.
PM-11S2UN01Eng.indd27 08.8.76:42:24PM
1. TECHNICAL SPECIFICATIONS
Power output
(20 Hz – 20 kHz simultaneous drive of both channels)
8
Ω
load ............................................................100 W x 2
4
Ω
load ............................................................200 W x 2
Total frequency distortion
(20 Hz – 20 kHz simultaneous drive of both channels, 8
Ω
load) ...0.01 %
Output band width (8
Ω
load, 0.05 %) ............. 5 Hz – 50 kHz
Frequency response (CD, 1 W, 8
Ω
load)
................................................5 Hz – 120 kHz ± 3 dB
Dumping factor (8
Ω
load, 20 Hz – 20 kHz) ......................100
Input sensitivity/Input impedance
PHONO (MC) ..............................................270 µV/100
Ω
PHONO (MM) ................................................3 mV/47 k
Ω
BALANCED .............................................. 480 mV/20 k
Ω
CD/LINE .................................................... 240 mV/20 k
Ω
Output voltage/Output impedance
PRE OUT .......................................................1.9 V/220
Ω
Maximum allowed PHONO input (1 kHz)
MC ......................................................................... 12 mV
MM ....................................................................... 130 mV
RIAA deviation (20 Hz – 20 kHz) ........................ ± 0.5 dB
S/N (IHF-A, 1 W, 8
Ω
load)
PHONO (MC : 0.5 mV input) ................................... 76 dB
PHONO (MM : 5 mV input) ..................................... 90 dB
BALANCED : 500 mV input .................................... 95 dB
CD/LINE : 500 mV input .......................................... 96 dB
Tone control
Bass (50 Hz) .......................................................... ± 8 dB
Treble (20 kHz) ....................................................... ± 8 dB
Power requirement
[/F] ................................................ AC 100 V 50/60 Hz
[/K] ...................................................... AC 220V 50 Hz
[/N] ................................................ AC 230 V 50/60 Hz
[/U] ..................................................... AC 120 V 60 Hz
Power consumption
J60065/EN60065 7th Ed./UL60065 ........................300 W
Accessories
Remote controller (RC-11PMS1) ....................................1
AAA batteries ..................................................................2
Detachable AC power cable ............................................1
Maximum outer dimensions (Amp)
Width .................................................. 17-3/8 in (440 mm)
Height .................................................. 6-5/8 in (168 mm)
Depth ................................................. 17-1/2 in (444 mm)
Weight (Amp) ................................................58.6 lb (26.6 kg)
2. CAUTION
The layout of this amplifier is well concerned for sound quality.
1. When screws and washers are removed, those parts must
be set to the same places.
2. When wires are removed, the wires must be installed in the
same roots, same places.
3. Do not hold the side panel (013D) to move the unit when
the unit is disassembled.
2. 注意
当機は音質を考慮したレイアウトになっています。
1. ネジやワッシャ類を取り外した場合、元の位置に取り付け
てください。
2. ワイヤ類を取り外した場合の配線ルートは、元のルート通
りに戻してください。
3. 当機を分解した状態で移動するときは、サイドパネル
(013D)を持たないでください。

Marantz PM-11S2 Specifications

General

Brand	Marantz
Model	PM-11S2
Category	Amplifier
Language	English