Marantz PM6006 - Connect and playback from a digital device (Coaxial;Optical)

Connect and playback from a digital
device (Coaxial/Optical)
1
Connect digital device to this unit. (v p. 22)
2
Press the input source select button (COAXIAL or
OPTICAL) to switch the input source to “COAXIAL” or
“OPTICAL 1/2”.
3
Start playback of the digital device connected to this
unit.
The COAXIAL or OPTICAL 1/2 input indicator flashes in blue if this
unit cannot detect the sampling frequency of the input signal.
4
Use VOLUME df to adjust the volume.
o
Specifications of supported audio formats
See “D/A converter” (v p. 42).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0
If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
Contents
Connections Playback Settings Tips Appendix
29
Front panel Rear panel
Remote control
unit
Index