Marantz SA8005 - Part Names and Functions; Select the Playback Media Mode; Stopping Digital Outputs; Switching the Displays Brightness

29
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
Stopping digital outputs
Stopping digital audio output reduces a source of noise that aects sound
quality, enabling higher sound quality playback.
1
During stop mode, press SETUP.
2
Use ui to select “Digital Out”, and press ENTER.
3
Use ui to select “O”, and press ENTER.
On (Default) : Outputs the digital signal.
O : Digital signal is not output.
%
• When digital output is turned o, the “DOFF” indicator lights up on the display.
• The “Digital Out” has a memory retention function where the settings remain
stored and unchanged even when the disc is changed or the power is turned o.
Select the playback media mode
1
Press INPUT to select the playback media mode.
Disc : Select to playback a disc.
USB : Select to playback an iPod or USB memory device.
USB-DAC / Coaxial / Optical :
Select to use this unit as a D/A converter.
%
• You can also select the media mode by pressing DISC/INPUT on the main unit.
Switching the display’s brightness
The display brightness can be adjusted between four levels. Switching the
display o reduces a source of noise that aects sound quality, enabling
higher sound quality playback.
1
Press DIMMER.
%
• When the display is turned o, the DISPLAY OFF indicator lights.
NOTE
• During stop mode, the display information does not turn o. The information is
turned o only during playback.