Marantz SA8005 - Auto Stnby; Digital out; USB Resume

55
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
USB Resume
This unit stores the point at which playback of a file was stopped previously,
and starts playback from the same point the next time playback is started.
On (Default) : Resume playback is set.
Remote : Resume playback is not set.
NOTE
• Resume playback works even if the USB memory device is disconnected and
then reconnected. However, if a dierent USB memory device is connected, the
resume information for the previous USB memory device is deleted.
• The resume information may be deleted when the USB memory device is removed
and files are added or deleted.
Digital Out
Switches the digital audio output on/o.
On (Default) : Use the digital audio output connector.
O : Do not use the digital audio output connector.
%
• When digital output is turned o, the “DOFF” indicator lights up on the display.
• The “Digital Out” has a memory retention function where the settings remain
stored and unchanged even when the disc is changed or the power is turned o.
Auto Stnby
A standby status is established at the unit if a stopped status or a no
external input signal status continues for 30 minutes or more.
On (Default) : Enable Auto Standby mode.
O : Disable Auto Standby mode.
%
• When iPod is being charged, this unit enters the power standby mode after
charging.