Connect and playback from a digital
device (Coaxial/Optical)
1
Connect digital device to this unit (vpage20).
2
Press INPUT to select the playback media mode to
“Coaxial” or “Optical”.
The input digital audio signal is displayed as shown.
“Coax: xxxxk” or “Opt : xxxxk”
(xxxx is the sampling frequency.)
• If the sampling frequency cannot be detected, “Unlock” will be
displayed.
2 Files that can be played back
See “D/A converter” (vpage68).
NOTE
• Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
• If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
To Next Page
Loading...
