Noise Shaper
Improves linearity and noise characteristics in the audible range using
digital feedback. The following degrees and methods can be set. The
measurements are the same but the sound quality changes. Set as
desired.
Balanced
(Default):
This is the best compromise between
highest signal to noise ratio and most open
and detailed sound stage.
Natural:
This gives high SNR for natural instruments
but may reduce some resolution.
Dynamic Music:
This improves the SNR but this cost
resolution in sound stage. Highest possible
dynamics for wideband music content in
this setting.
Dynamic Voice:
Even higher SNR but only up to 5 kHz. This
gives highest possible dynamics for natural
instruments and voices.
NOTE
0
The Noise Shaper function does not work when playing a Super Audio CD or DSD
audio source.
Digital Out
Stopping digital audio output reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
On
(Default):
Use the digital audio output connector.
Off: Do not use the digital audio output connector.
Contents Connections Playback Settings Tips Appendix
56
Front panel Rear panel Remote control
unit
Index
To Next Page
Loading...
