HP Amplifier Gain
Set the gain of the headphone amplifier. Set this according to the
impedance of the connected headphones. It is recommended that this is
set on the “Low” side if the headphones have low impedance and on the
“High” side if they have high impedance.
High:
Set the gain of the headphone amplifier to
“High”. Set this if the volume is too low at the
factory default setting.
Mid
(Default):
Set the gain of the headphone amplifier to
“Mid”.
Low:
Set the gain of the headphone amplifier to
“Low”. Set this if the volume is too high at the
factory default setting.
NOTE
0
The headphone volume varies depending on the “HP Amplifier Gain” setting.
Decrease the volume or mute the audio first if changing this setting while listening
to audio.
Resume Play
When the input source is switched, the USB flash drive is disconnected
and then connected, or the power is turned off and then back on during
USB flash drive playback, the unit memorizes the point where playback
stopped (resume information) so that playback can resume from after that
point.
On
(Default):
Resume playback is set.
Off: Resume playback is not set.
NOTE
0
Resume playback works even if the USB flash drive is disconnected and then
reconnected. However, if a different USB flash drive is connected, the resume
information for the previous USB flash drive is deleted.
0
The resume information may be deleted when the USB flash drive is removed and
files are added or deleted.
0
Press i while playback is stopped to delete the resume information. “Resume Off”
is displayed.
Contents Connections Playback Settings Tips Appendix
57
Front panel Rear panel Remote control
unit
Index
To Next Page
Loading...
