Menu map
For menu operations, see the following page.
By default, this unit has recommended settings defined. You can customize this unit based on your existing system and your preferences.
Setting items Detailed items Description Page
Audio Filter
This unit is equipped with a sound quality adjusting function which allows users to enjoy
the desired playback sound quality.
55
Dither
This function adds audio data to minimize quantization error. Audio data to be added
can be set on this unit. The sound quality changes. Set as desired.
55
Noise Shaper
Improves linearity and noise characteristics in the audible range using digital feedback.
The measurements are the same but the sound quality changes. Set as desired.
56
Digital Out
Stopping digital audio output reduces a source of noise that affects sound quality,
enabling higher sound quality playback.
56
HP Amplifier Gain
Set the gain of the headphone amplifier. 57
Resume Play
When the input source is switched, the USB flash drive is disconnected and then
connected, or the power is turned off and then back on during USB flash drive playback,
the unit memorizes the point where playback stopped so that playback can resume from
the beginning of that track.
57
General Illumination
This function adjusts the illumination of the front panel and the brightness of the display.
It also enables linkage of the front panel illumination to the brightness of the display.
When the brightness is turned “Off”, the noise source affecting the sound quality is
suppressed, and high-quality sound playback is possible.
58
Auto-Standby
Sets whether to automatically switch the unit to the standby mode when there is no
audio input and no operations are performed for more than 15 minutes.
58
Contents Connections Playback Settings Tips Appendix
53
Front panel Rear panel Remote control
unit
Index
To Next Page
Loading...
