NOTE
0
Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0
When this unit is functioning as a D/A converter, sound is not output from the
computer’s speakers.
0
If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0
When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0
The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0
Use a cable that is 3 m or less to connect to the computer.
Connecting and playing back from a
digital device (Coaxial/Optical 1/Optical
2)
1
Connect digital device to this unit. (v p. 22)
2
Press COAXIAL or OPTICAL to switch the input source
to “Coaxial”, “Optical 1” or “Optical 2”.
0
Pressing OPTICAL changes the input source to “Optical 1” or
“Optical 2”.
3
Play the component connected to this unit.
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
o
Specifications of supported audio formats
See “Digital input” (v p. 82).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes
noise and could damage the speakers.
Contents Connections Playback Settings Tips Appendix
52
Front panel Rear panel Remote control
unit
Index
To Next Page
Loading...
