Marantz SR5010/U1B - Page 71

z
5,
z
7 -
z
10: “Sound modes and surround parameters”
z
1 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS
signal is played.
z
2 This item can be selected when a Dolby TrueHD, Dolby Digital, Dolby Atmos, DTS:X or DTS signal is played.
z
3 This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z
4 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z
5 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z
6 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”.
z
7 This item cannot be set when “Dynamic EQ” is set to “On”.
z
8 This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed.
z
9 This item cannot be set when “MultEQ® XT” is set to “Off”.
z
10 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Sound mode
Surround Parameter
Tone
z7
Audyssey
M-DAX
z10
Center Spread DTS Neural:X
MultEQ® XT
z8
Dynamic EQ
z9
Dynamic Volume
z9
Direct/Pure Direct (2-channel) z5
Direct/Pure Direct (Multi-channel) z5
Stereo
SSSSS
Multi Ch In
SSSS
Dolby Surround
SSSSSS
DTS Neural:X
SSSSS
Dolby Digital
SSSS
Dolby Digital Plus
SSSS
Dolby TrueHD
SSSS
Dolby Atmos
SSSS
DTS Surround
SSSS
DTS 96/24
SSSS
DTS-HD
SSSS
DTS Express
SSSS
DTS:X
SSSSS
Multi Ch Stereo
SSSSS
Virtual
SSSSS
71