How to disable HDMI control on Marantz SR6006 Receiver?
If your Marantz Receiver is mirroring operations from other HDMI-connected devices (like power, volume, or input source changes), go to the menu and set “HDMI Control” – “Control” to “OFF”. To prevent linked power-off operations, also set “Power Off Control” to “OFF”.
Why is there no audio output from my Marantz SR6006?
If audio is not outputting from your Marantz Receiver, check the following: * Verify all device connections. * Check speaker connections and configurations. * Ensure the audio device is powered on. * Adjust the master volume and ensure mute mode is off. * Select the correct input source and mode. * Disconnect headphones, as this may disable speaker and PRE OUT connector output.
What to do if no video is output with HDMI connection on Marantz SR6006 Receiver?
If you're not getting any video output via HDMI on your Marantz Receiver: * Check the HDMI cable connections. * Ensure the input source matches the connected HDMI port. * Verify that your TV is compatible with HDCP (copyright protection). Incompatibility may prevent proper video output.
What to do if audio is not outputting from Marantz SR6006?
If your Marantz Receiver isn't outputting any audio, consider the following: * Verify all device connections. * Inspect speaker connections and configurations. * Ensure the audio device is powered on. * Adjust the master volume. * Deactivate mute mode. * Select the correct input source and mode. * Disconnect headphones, as this may prevent sound from the speakers or PRE OUT connectors.
How do I turn on the display on my Marantz Receiver?
If the display on your Marantz Receiver is off, set “Display” on the menu to something other than “OFF”.
Why is there no sound from the subwoofer connected to my Marantz SR6006?
If your subwoofer isn't producing sound with your Marantz Receiver: * Verify the subwoofer connections. * Ensure the subwoofer is powered on. * In the menu, set “Speaker Config.” – “Subwoofer” to “Yes”. * Note that if “Front” and “Center” are set to “Large” and “Subwoofer Mode” is set to “LFE”, sound output may vary based on the input signal or surround mode.
How to troubleshoot a Marantz SR6006 that does not turn on?
If your Marantz Receiver isn't powering on: * Check that the power plug is correctly inserted into the power outlet. * The protection circuit might be active. Disconnect the power plug, wait 5-10 seconds, and then reconnect it.
What does it mean when the power indicator is blinking red in intervals of approximately 0.5 seconds after turning on the Marantz SR6006?
If, after turning on your Marantz Receiver, the power indicator blinks red every 0.5 seconds, the unit's amplifier circuit has likely failed. Turn off the power and contact a Marantz service advisor.
Why is there no sound from front height speaker on Marantz SR6006?
If there's no sound from the front height speakers on your Marantz Receiver: * Check if “Amp Assign” is correctly configured to output audio from the front height speakers. * Ensure “Speaker Config.” – “Front Height” is set to something other than “None” in the menu.
Why is there no sound from surround back speaker on Marantz Receiver?
If there's no sound from the surround back speakers on your Marantz Receiver: * Verify that “Amp Assign” is correctly configured to output audio to the surround back speakers. * Ensure “Speaker Config.” – “Surr.Back” is not set to “None” in the menu. * The surround mode must be set to something other than “STEREO” or “VIRTUAL“.
General| Receiver type | Surround |
|---|---|
| Pre-out channels | 7.2 |
| Speaker selector | A+B |
| Pre-out connectivity | Yes |
| Audio output channels | 7.1 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Power output per channel (1KHz@6 Ohm) | 125 W |
| Power output per channel (20-20KHz@8 Ohm) | 110 W |
| HDMI in | 7 |
| Composite video in | 5 |
| Ethernet LAN (RJ-45) ports | 1 |
| Component video (YPbPr/YCbCr) in | 2 |
| Multichannel audio output type | Terminals |
| Connectivity technology | Wired |
| Speakers connectivity type | - |
| Audio formats supported | AAC, FLAC, MP3, WAV, WMA |
| Image formats supported | JPG |
| Wi-Fi | No |
| Supported radio bands | FM |
| Internet radio services supported | Last.fm, vTuner |
| Product color | Black |
| Audio decoders | Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic IIz, Dolby TrueHD, DTS, DTS 96/24, DTS-ES, DTS-HD Master Audio |
| Volume control | Rotary |
| Apple docking compatibility | iPod |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (standby) | 0.2 W |
| Power consumption (typical) | 650 W |
| Supported video modes | 1080p |
| Supported graphics resolutions | 1920 x 1080 (HD 1080) |
Weight and Dimensions| Depth | 389 mm |
|---|---|
| Width | 440 mm |
| Height | 161 mm |
| Weight | 11400 g |
To Next Page
