Why can't I select Dolby PLg mode or DTS NEO:6 mode on Marantz SR6006?
If you can't select Dolby PLg or DTS NEO:6 mode on your Marantz Receiver: * Make sure that “Speaker Config.” – “Center” or “Surround” is not set to “None”. This mode cannot be selected with a 2.0/2.1ch speaker system. * Dolby PLg or DTS NEO:6 cannot be selected when headphones are in use.
General| Receiver type | Surround |
|---|---|
| Pre-out channels | 7.2 |
| Speaker selector | A+B |
| Pre-out connectivity | Yes |
| Audio output channels | 7.1 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Power output per channel (1KHz@6 Ohm) | 125 W |
| Power output per channel (20-20KHz@8 Ohm) | 110 W |
| HDMI in | 7 |
| Composite video in | 5 |
| Ethernet LAN (RJ-45) ports | 1 |
| Component video (YPbPr/YCbCr) in | 2 |
| Multichannel audio output type | Terminals |
| Connectivity technology | Wired |
| Speakers connectivity type | - |
| Audio formats supported | AAC, FLAC, MP3, WAV, WMA |
| Image formats supported | JPG |
| Wi-Fi | No |
| Supported radio bands | FM |
| Internet radio services supported | Last.fm, vTuner |
| Product color | Black |
| Audio decoders | Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic IIz, Dolby TrueHD, DTS, DTS 96/24, DTS-ES, DTS-HD Master Audio |
| Volume control | Rotary |
| Apple docking compatibility | iPod |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (standby) | 0.2 W |
| Power consumption (typical) | 650 W |
| Supported video modes | 1080p |
| Supported graphics resolutions | 1920 x 1080 (HD 1080) |
Weight and Dimensions| Depth | 389 mm |
|---|---|
| Width | 440 mm |
| Height | 161 mm |
| Weight | 11400 g |
To Next Page
