Marantz SR6007 - Zone Rename; Auto Standby; Trigger out; Front Display

136
Zone Rename
Change the display title of each zone to one you prefer.
Setting details
MAIN ZONE / ZONE2
•Up to 10 characters can be input.
•For character input, see page108.
Trigger Out
Selects when to activate trigger out.
For details about how to connect the DC OUT jacks, see “DC OUT jack” (vpage94).
Setting details
n When setting for zone (MAIN ZONE / ZONE2)
Trigger out is activated through linkage to the power of the zone set to “On”.
n When setting for input source
Activate trigger out when the input source set to “On” is selected.
Active for the zone set to “On” with “When setting for zone”.
•On : Activate trigger on this mode.
•– – – : Do not activate trigger on this mode.
Auto Standby
Default settings are underlined.
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, “Auto Standby” is
displayed on the display of this unit and the menu screen.
Setting details
30min : The unit goes into standby after 30 minutes.
60min : The unit goes into standby after 60 minutes.
Off : The unit does not go into standby automatically.
Front Display
Default settings are underlined.
Adjust the display brightness of this unit.
Setting items Setting details
Display
On : Display is always on.
Auto OFF : Display is off except when showing the status display.
Off : Display is always off.
This can also be set by pressing DISPLAY on the main unit.
Each time DISPLAY is pressed, the setting is changed as shown
below.
On Auto Off
Off
NOTE
When “Display” is set to “Off”, the display turns off and appears as if
there is no electricity.
General
Basic version
Advanced version
Information
Advanced version
DVD