Marantz SR6008 - Input Mode

162
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Input Select
Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
2 Input Mode
Set the audio input modes for the dierent input sources.
It is normally recommended to set the audio input mode to “Auto”.
Auto (Default) : Automatically detect input signal and perform playback.
HDMI : Play only signals from HDMI input.
Digital : Play only signals from digital audio input.
Analog : Play only signals from analog audio input.
7.1CH IN : Only signals input from the 7.1CH IN connector will be
played back.
%
•If “HDMI Control” is set to “On” and a TV compatible with the ARC is
connected via the HDMI MONITOR connectors, the input mode whose input
source is “TV AUDIO” is fixed to ARC.
•The sound mode cannot be set if the input mode is set to “7.1CH IN”.
2 Decode Mode
Set the audio decode mode for input source.
Auto (Default) : Detect type of digital audio input signal and decode and
play automatically.
PCM : Decode and play only PCM input signals.
DTS : Decode and play only DTS input signals.
%
•This item can be set for input sources for which “HDMI” or “DIGITAL” is
assigned at “Input Assign” (vpage159).
•Normally set this mode to “Auto”. It is recommended to set “PCM” or “DTS”
when audio is missing at the beginning or a noise occurs.