Marantz SR6008 - Page 41

41
Appendix
TipsSettingsPlayback
Contents
Front panel Display Rear panel IndexRemote
Connections
Connecting a turntable
This unit is compatible with turntables equipped with a moving magnet (MM) phono cartridge. When you connect to a turntable with a low output moving
coil (MC) cartridge, use a commercially available MC head amp or a step-up transformer.
If you set this unit’s input source to “PHONO” and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
FRONT
SUBWOOFER
SURROUND SURROUND BACK CENTER 1 CBL/SAT 2 DVD 3 Blu-ray 4 MEDIA PLAYER 5 CD
COAXIAL
OPTICAL
CBL/SAT
1
DVD
2
1
TV
AUDIO
2
CD
1 CBL/SAT
2 DVD
3 Blu-ray
4 GAME
5 MEDIA PLAYER
6 AUX2
STRAIGHT CABLE DC12V 150mA MAX.
IN
MONITOR
P R /
C R
P R /C R
P B /
C B
P B /C B
Y
Y
1 CBL/SAT
3 Blu-ray
1 CBL/SAT
MONITOR
2 DVD
2 DVD
IN
OUT
NETWORK
RS-232CDC OUT
FLASHER
COMPONENT VIDEO OUT
7.1CH IN PRE OUT
M-XPort
(
ASSIGNABLE
)
DIGITAL AUDIO IN
(
ASSIGNABLE
)
(
ASSIGNABLE
)
AUDIO IN
(
ASSIGNABLE
)
COMPONENT VIDEO INVIDEO OUT
SURROUND SURROUND
FRONT FRONT
CENTER SURROUND BACK SURROUND BACK FRONT HEIGHT/WIDE FRONT HEIGHT/WIDE
VIDEO IN
REMOTE
CONTROL
SURROUND SURROUND BACK FRONT CENTER ZONE2
1 2
SUBWOOFER
SPEAKERS
ASSIGNABLE
HDMI IN
(
ASSIGNABLE
)
AC IN
SURROUND SURROUND
FRONT FRONT
CENTER SURROUND BACK SURROUND BACK FRONT HEIGHT/WIDE FRONT HEIGHT/WIDE
ZONE2
MONITOR
ARC
HDMI OUT
SIGNAL
GND
AUDIO IN
PHONO
FM
ANTENNA
(
75Ω
)
IMPEDANCE : 6～8Ω
GND
AUDIO
OUT
L
R
Turntable
(MM cartridge)
%
•When a device is connected to the SBL/SBR terminal of 7.1CH
IN connectors, set “Assign Mode” (vpage 172) to “Main
Only”.
NOTE
•The ground line (SIGNAL GND) on this unit is not a safety
ground. Note that depending on the turntable, connecting the
ground line may have the reverse eect of increasing noise. In
this case, it is not necessary to connect the ground line.