22
Service manual April 2017 Uber boiler
3.3.1 Flow Rate Adjustment:
The ball valve on the back of the tank should be set to the approximate position as shown
below. When the tank is full (displaying PRIME READY FULL) press Boost and change up to
94.5-95.5°C. Place an empty container on the scale and zero the scale. Fully open the
dispense dial on the font and at the same time start the timer, close the dial after 20seconds.
Note the weight of the water, if it is out of the 650-850g range, then adjust the ball valve.
Turning the valve handle up so it is inline with the pipe (open) will decrease flowrate from the
font. Now screw on the back panel ensuring the hose is not kinking. Repeat the 20second
flow test (this is to ensure the hose is not kinked or compressed after the back panel is in
place).
To Next Page
Loading...
