29
Service manual April 2017 Uber boiler
3.6.3 Platform Adjustment Screws:
Place springs on the 16mm nylon screws and screw them into the rivet nuts. Use a ruler or
other straight edge to visually ensure all 4 screw heads are level and approximately 2mm
below the surface of the tile –be careful not to scratch the tile. (Nylon screws should be used
even though stainless steel screws are shown in the photo).
Replace the service panel and the machine is ready to use. The machine will require the
weighing scale to be recalibrated.
To Next Page
Loading...
