25
You may elect not to use either record output with this particular
device, as may be the case if you have several devices in your sys-
tem that are capable of recording. In this case, leave the display on
“RCD: NONE” and move to Step 6.
You may also select either record output 1 or 2 to be associated
with this particular input. To do so, press the input button repeat-
edly until you see your choice of OUT1 or OUT2 in the display.
(OUT1 is given as an example below.)
6 Store your selection
Save your choice in nonvolatile memory by pressing and holding
the Mode button until the display reads NEW DATA, as below.
results of
unrealistic tests
The Nº380 Preamplifier has been optimized to yield optimum sonic
performance under normal, real-world operating conditions. This ap-
proach involves no disadvantage when the unit is used as designed.
Unrealistic tests such as listening at full gain to an unterminated input
which has been associated with an unterminated record output may re-
sult in some small amount of noise at the main output which does not
occur when the Nº380 is used correctly. Moreover, even under these
unrealistic test conditions, any resulting noise is small and poses no
danger.
To Next Page