Martin ATOMIC 3000 - To Program a Multi-Fixture Chase

22 Remote controls Atomic 3000 user manual
To program a multi-fixture chase
1 Connect the fixtures and Detonator.
2 Select the fixture to start the flash sequence and set it to master mode as
described above.
3 Set the number of fixtures in the chase on the master fixture’s Address DIP
switch. There may be 2 to 20 fixtures in a chase.
4 Set each additional fixture to slave mode on its Mode DIP switch. On its
address DIP switch, set the slave’s position in the chase sequence. Set 2 on
the second fixture to flash, 3 on the third fixture, and so on up to 20.
102 3451 86 7 9
ON
2
102 3451 86 7 9
ON
3
102 3451 86 7 9
ON
4
102 3451 86 7 9
ON
5
102 3451 86 7 9
ON
6
102 3451 86 7 9
ON
7
102 3451 86 7 9
ON
8
102 3451 86 7 9
ON
9
102 3451 86 7 9
ON
10
102 3451 86 7 9
ON
11
102 3451 86 7 9
ON
12
102 3451 86 7 9
ON
13
102 3451 86 7 9
ON
14
102 3451 86 7 9
ON
15
102 3451 86 7 9
ON
16
102 3451 86 7 9
ON
17
102 3451 86 7 9
ON
18
102 3451 86 7 9
ON
19
102 3451 86 7 9
ON
20