6 Preparation for use Atomic 3000 user manual
P
REPARATION
FOR
USE
2
UNPACKING
The Atomic 3000 comes with the following items:
• Martin MAX-15 or MAX-7 xenon lamp (installed)
• Mounting bracket
• User manual
The packing material protects the fixture during shipment; always use it to
transport the fixture.
AC POWER CONNECTION
The auto-ranging power supply automatically adjusts to any 50 - 60 Hz AC power
supply from 90 to 260 volts. No adjustment is necessary. Note that the MAX-15
lamp does not operate below 125 volts.
The current required by the Atomic 3000 varies according to lamp type, power
mode, and usage. To avoid overload, allow one 16 or 20 amp branch circuit per
fixture to operate the MAX-15 model at full power. Two fixtures may be placed
on a 16 amp branch circuit if they are operated in low power mode or use the
MAX-7 lamp.
Use 2.5 mm
2
(13 AWG) or larger power feed cables and keep runs as short as
possible.
To install a plug on the mains lead
The mains lead must be fitted with a heavy duty cord cap with ground connection.
Consult a qualified electrician if you have any doubts about proper installation.
To Next Page
Loading...
Need help?
General
