Introduction 7
Introduction
Thank you for selecting the MAC 101™, an intelligent lighting fixture from Martin Professional™. This range
of compact LED-based moving-head washlight includes four models:
All MAC 101 fixtures feature:
• DMX control
• Onboard control panel and backlit LCD graphic display
• Smooth electronic dimming
• Electronic shutter with strobe and pulse effects
• 540° pan and 240° tilt ranges
The standard MAC 101 features:
• RGB color mixing with color temperature control
• Cree XP-E high-power RGB emitters
• ‘Color wheel’ color-snap feature
• Three DMX control modes:
- Raw RGB + CTC
- Calibrated RGB + CTC
- Basic (color-wheel only, RGB + CTC disabled)
The MAC 101 CT features:
• Warm/cold white mixing with 2800 - 6200 K color temperature control
• Cree XP-E high-power warm and cold white emitters
The MAC 101 WRM features
• 2800 K color temperature
• Cree XP-E high-power warm white emitters
The MAC 101 CLD features:
• 6700 K color temperature
• Cree XP-E high-power cold white emitters
For the latest firmware updates, documentation, and other information about this and all Martin Professional
products, please visit the Martin website at http://www.martin.com
Comments or suggestions regarding this document may be e-mailed to service@martin.dk or posted to:
Technical Documentation, Martin Professional A/S, Olof Palmes Allé 18, DK-8200 Aarhus N, Denmark.
Using for the first time
Warning! Read “Safety Information” on page 3 before installing, powering, operating or servicing
the MAC 101. Before applying power to the fixture:
• Check the Martin Professional website at www.martin.com for the most recent user documentation and
technical information about the MAC 101. Martin user manual revisions are identified by the revision letter
at the bottom of page 2.
• Carefully review “Safety Information” starting on page 3.
• Check that the local AC mains power source is within the fixture’s power voltage and frequency ranges.
• See “Power cables and power plug” on page 8. Install a Neutrik PowerCon NAC3FCA power input
connector on a suitable power cable. If drawing power from a mains power outlet, install a suitable power
plug on the power cable.
To Next Page
Loading...
Need help?
General
