Marus CL1000 - Light Focus Adjustments; Yoke Pivot Friction Adjustment

15
Overview / Replacement Parts
Controls
The on-off switch is located on the control panel directly above the light reector. The long toggle provides
easy, one-motion movement to “ick” the light on or off. When the handle is in the up position, the light is
on, the down position turns the light off.
A 3-position, rocker-type switch is located adjacent to the on-off switch on the control panel. Depressing the
upper portion of the switch places the intensity control in the “HIGH” position allowing the light to emit its
maximum brilliance. An intermediate or “MEDIUM” intensity is obtained by placing the switch in the in-be-
tween position and the lowest intensity by depressing the lower portion of the switch.
The Marus light is equipped with a spare bulb in the rear of the light head. If the bulb should happen to fail,
replace it with the spare bulb provided. See Bulb Replacement section, page 16.
On-Off Switch
Intensity Switch
Spare Bulb
Figure 11
Cover
52R523-1
Cover Retainer
52R256
Bushing Retainer
52R255
Upper Transformer
Cover
52R146
Lower Transformer
Cover
22097
Serial# / Model#
Set Screw
022R046
Set Screw
022R006
Front End Cap
52R110
Rear End Cap
52R121
End Cap
52R170
On / Off Switch
52R442
Bezel
52R450
Reflector Shield
52R430
Light Handle
52R438-1
Lamp Shield
85R209
Lamp
014R207
Yoke Pivot Cap
22076
Reflector
52R412
Intensity Switch
014R306
Spare Bulb