Marus CL1000 - General Information; Definition of Symbols; Product Disposal; Interference with Electromedical Devices

2
The following symbols may be used throughout
this manual:
CAUTION. Failure to carefully follow the described
procedure may result in damage to the equipment.
WARNING. Failure to carefully follow the described
procedure may result in damage to the equipment
and/or operator/patient injury.
Risk of electrical shock present.
Ensure power is disconnected before attempting
this procedure.
General Information
Denition of Symbols
Product Disposal
Contact your local authorized dealer for proper disposal
of the device to ensure compliance with your local
environmental regulations.
Interference with Electromedical
Devices
To guarantee the operational safety of electromedical
devices, it is recommended that the operation of mobile
radio telephones in the medical practice or hospital be
prohibited.
Strong EMI sources such as electro surgery units or
x-ray units may affect performance. If performance
problems occur, move the light to another electrical
circuit or physical location.
Incompatible Devices and/or
Accessories
For reasons of product safety, only original manufacturer
devices & accessories approved for this product, or
accessories from third parties which have been released
by the manufacturer may be used. It is the user’s risk
when using non-released accessories are used.
Obtaining Technical Literature
The manufacturer will make available on request circuit
diagrams, component parts lists, descriptions, calibration
instructions or other information that will assist technical
personnel to repair and replace serviceable items.
Product Identication
This dental light can be identied by its product label,
located on product. This label states the light model and
serial number, electrical specications, manufacture
date and safety classication. Note the SAMPLE labels
shown below.
Waste Electrical and Electronic Equipment
Protective Earth (Ground)
Manufacturing date
Type B Equipment
(Protected against electrical shock)
Dangerous Voltage
Electrical Testing Lab
AC (Alternating Current)
EN60601-1-2, UL60601-1
Dental Light
Marus
11727 Fruehauf Drive
Charlotte, NC 28273 USA
MN
SN
92162• Rev.5 •02/12
115 VAC, 60HZ, 1.09A
IEC Type B, Class 1, IPX4
Operation Mode: Intermittent
Conforms to:
Certified to:
CAN/CSA - C22.2 NO.601.1
59768
EN60601-1-2, UL60601-1
Dental Light
Marus
11727 Fruehauf Drive
Charlotte, NC 28273 USA
MN
SN
92163 • Rev.5 • 02/12
230 VAC, 50HZ, 0.6A
IEC Type B, Class 1, IPX4
Operation Mode: Intermittent
Conforms to:
Certified to:
CAN/CSA - C22.2 NO.601.1
59768
WARNING: This product is intended
for use by trained dental/medical
professionals only.
Authorized European Representative:
Medical Device and QA Services
76, Stockport Road
WA15 7SN
United Kingdom
e-mail: info@mdqa.co.uk
Identication mark that indicates the product
complies with the health & safety requirements
as published by European Directives.