＿
US-6
＿
HOT RESTART
To start the engine that is already warmed up (hot restart):
1. Pump the primer bulb until fuel can be seen owing through
the fuel return line. (Flowing fuel should be almost clear, not
foamy or full of bubbles.)
2. Turn the choke lever to the Open “ ” position, and set the
stop switch to the “ /ON” position.
3. Leave the throttle trigger in the idle position and pull the starter
grip.
4. If the engine fails to start after three to four pulls, follow the
instructions in the Cold Starting Procedure section above.
If the engine fails to start after you follow the above proce-
dures, contact an authorized MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Move the stop switch to “ /OFF” position.
OPERATING INSTRUCTIONS
Starting and Stopping
COLD STARTING PROCEDURE
The carburetor on this engine is equipped with a fuel primer and
a choke system. To start a “cold” engine properly, perform the
following procedure:
1. Pump the primer bulb until fuel can be seen owing through
the fuel return line. (Flowing fuel should be almost clear, not
foamy or full of bubbles.)
2. Turn the choke lever to the Close “ ” position.
3. With the stop switch “ /ON”, and pull the starter grip.
After the engine is started, turn the choke lever to the Open “ ”
position.
If the engine stops running before you turn the choke lever to the
Open
“ ”
position:
Go ahead and open the choke
“ ”
, pull the starter grip.
/ON
/OFF
Throttle trigger
Starter Grip
Fuel Return Line
Primer Bulb
Choke Lever
Stop Switch
/ON
/OFF
Throttle trigger
Stop Switch
Close
Open
Choke Lever
To Next Page
Loading...
