Maruyama BC230 - Cutting Blade; Before Operation

＿
US-5
＿
CUTTING BLADE
A variety of metal cutting blades are available
to satisfy di󰀨erent cutting conditions. It is
especially important to use only the correct
blade(s) approved for brushcutter. Also, it is
especially important to install the blade for
LEFT- HAND rotation (as viewed from the
operator’s position), and to correctly position
all blade holding parts (see sketch).
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two stroke engines used in the brushcutter requires a mixture of GASOLINE and OIL for lubrication of
bearings and other moving parts. See the chart below.
NOTE
: Gasoline and oil must be premixed in a clean gasoline container. Never mix gasoline and oil in-
doors or in the burushcutter fuel tank. Always use fresh gasoline.
WARNING !! - NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before lling the brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter the
fuel tank. Always shake the fuel container before lling the fuel tank. Remove the fuel cap, then ll the fuel
tank to within about 10mm from the top of the tank. Avoid lling the fuel tank ller neck. Install the cap se-
curely onto the fuel tank.
Fuel Mixture Chart
Gasoline
Two-stroke oil
50:1 25:1
ISO-L-EGC/ EGD ,JASO class FC/ FD,
or equivalent two-stroke oil
ISO-L-EGB , JASO class FB,
or equivalent two-stroke oil
1 liter 20 mL 40 mL
2 liters 40 mL 80 mL
5 liters 100 mL 200 mL
Stabilizer
Blade nut
Left hand
thread
Clamping WasherCutting Blade
Boss Adapter
Gearcase
Holding Tool
(3mm Hex Wrench)