Masai K50 - Reed Valve; Removal; Installation

15 Reed valve
15.1 Removal
• Remove the carburettor
• Remove the mudflap.
• Loosen the screws of the intake elbow
and remove the intake elbow.
• Remove the reed valve
• Remove the gasket.
Figure 62: Intake elbow
15.2 Installation
The installation goes into the reverse order of the removal.
• Install the gasket. Always use a new gasket.
• Install the reed valve.
• Install the intake elbow.
Torque value:
Screws of the intake elbow: 9 Nm (6,6 lbft)
• Install the mudflap.
SERVICE MANUAL MASAI K50
40